THORLABS TSP01 User Manual (English)

To Next Page

To Previous Page

TSP01

3. *OPC? – operation complete query – places a “1” in output queue

When *OPC is sent, the OPC bit in the Standard Event Register will set after all pending com-

mand operations are complete. When *OPC? is sent, an ASCII “1” is placed in the Output

Queue after all pending command operations are complete.

Typically, either one of these commands is sent after the INITiate command. The INITiate

command is used to take the instrument out of idle in order to perform measurements. While

operating within the trigger model layers, many sent commands will not execute. After all pro-

grammed operations are completed, the instrument returns to the idle state at which time all

pending commands (including *OPC and/or *OPC?) are executed. After the last pending com-

mand is executed, the OPC bit and/or an ASCII “1” is placed in the Output Queue.

4. *RST – reset – return instrument to defaults

When the *RST command is sent, the instrument performs the following operations:

· Cancels all pending commands.

· Cancels response to any previously received *OPC and *OPC? commands.

5. *TST? – self-test query – run self test and read result

Use this query command to perform the instrument self-test routine. The command places the

coded result in the Output Queue. A returned value of zero (0) indicates that the test passed,

other values indicate that the test failed.

6. *WAI – wait-to-continue – wait until previous commands are completed

The *WAI command is a no operation command for the instrument and thus, does not need to

be used. It is there for conformance to IEEE488.2.

4.2.2.2 SCPI Command Reference

SYSTem subsystem commands

Command

Description

SCPI

SYSTem

Path to SYSTem subsystem

:ERRor

[:NEXT]?

Returns the latest error code and message

:VERSion?

Returns level of SCPI standard (1999.0)

STATus subsystem commands

Command

Description

SCPI

STATus

:OPERation

Path to control operation event registers

[:EVENt]?

Returns the event register

:CONDition?

Returns the condition register

:ENABle <value>

Sets the enable register

:ENABle?

Returns the enable register

:QUEStionable

Path to control questionable event registers

[:EVENt]?

Returns the event register

:CONDition?

Returns the condition register

:ENABle <value>

Sets the enable register

:ENABle?

Returns the enable register

:PRESet

Set status registers to default states.

Other manuals for THORLABS TSP01

Quick Start23 pages

Need help?

Do you have a question about the THORLABS TSP01 and is the answer not in the manual?

THORLABS TSP01 Specifications

General

Type	Temperature and Humidity Sensor
Display	LCD
Interface	USB
Temperature Measurement Range	-40 to 100 °C
Temperature Measurement Accuracy	±0.5 °C
Humidity Measurement Range	0 to 100% RH
Dew Point Measurement Range	-40 °C to 100 °C
Dew Point Measurement Accuracy	±1 °C
Sampling Rate	1 Hz
Power Supply	USB Powered
Operating System Compatibility	Windows
Humidity Measurement Accuracy	±2 %RH (10 %RH to 90 %RH at 25 °C)