© 2018 Thorlabs
3 Operating Instructions
7
3 Operating Instructions
After installation of the software connect the TSP01 to a free USB 2.0 port.
Note
The TSP01 should always be positioned away from heat and humidity sources that are not of
interest for the measurement to prevent background. For this, the 1.8 m USB cable is supplied
to position the TSP01 away from the PC/HUB.
The operating system recognizes a USB device and automatically installs the device drivers.
Start the GUI from the desktop icon.
For detailed information on how to use the TSP01 Application software, please see
the chapter Detailed GUI Description .
3.1 Quick Start
This chapter gives a short overview on how to use the TSP01 Application. A detailed descrip-
tion of the GUI can be found in the chapter Detailed GUI Description .
At the first connect, you will be prompted to select the pre-
ferred unit for temperature display. Confirm your choice
with "OK". The software now automatically connects to the
TSP01 and the actual temperature and relative humidity
are displayed as measured on the internal sensor. If an ex-
ternal sensor is connected, it will be recognized and en-
abled automatically, and the temperature of the external
sensor is now displayed.
11
11
To Next Page
Loading...
Need help?
General
