USERS MANUAL NOVA SERIES
www.thunderlaser.com DONGGUAN THUNDER LASER EQUIPMENT CO.,LTD
tech@thunderlaser.com Shatian Town, Shatian Dadao, Mintian
Tel :(86)769 826653 Dongguan City, Guangdong Province, China
Chapter 3. Process of Installing
3.1 Unpacking
You receive your THUNDER LASER NOVA SERIES packed in a wooden box which
contains the laser machine and additional accessories. The following steps give you an
overview of the unpacking and assembly of the laser. Please follow these steps carefully.
Keep the packing box. You will require it in case of a return.
Dispose all waste according to the applicable waste disposal law.
1. Put the wooden box on a flat and spacious room for unpacking.
2. Remove the machine box; carefully remove the protective foam, wraps, films, etc…
3. Take out the key，open the door of the laser, remove the accessories box which contains
all accessory parts required for the installation of the laser machine and check the contents
carefully.
4. You will see an attachment table on the machine; please check whether the accessories
are all on the table.
5. Please keep the keys and the warranty certificate as well as the model and serial number
of the machine. If you need tech support we may ask you for this information.
6. Remove the sponges and nylon cable ties from inside the machine, and then start to
install the machine, carefully following the instructions in this manual.
To Next Page
Loading...
