Thunder Laser NOVA Series - Connecting the Exhaust System

USERS MANUAL NOVA SERIES
www.thunderlaser.com DONGGUAN THUNDER LASER EQUIPMENT CO.,LTD
tech@thunderlaser.com Shatian Town, Shatian Dadao, Mintian
Tel :(86)769 826653 Dongguan City, Guangdong Province, China
27
27
3.8.4 Connecting the Exhaust System
How to set up the exhaust system
Insert one side of the gray exhaust pipe into the fan inlet and the other side into the fuselage
behind the exhaust tank. Insert one side of the gray exhaust pipe into the fan outlet and
put the other side of the pipe outside where you work (If the machine is far from the outside
of the room that the gas manufactured by the machine cannot be discharged; then you
might need an dust/fume filter, it can keep the air quality of your working environment well).
Please refer to the following pictures about how to install the exhaust pipe:
Also you can refer to the video on how to set up your Nova laser machine in our website
http://www.thunderlaser.com/how-to-use-your-laser-machine/how-to-setup-your-nova-
laser-cutter.html
A customized anti-shock foam that came with the exhaust fan can be
placed under the exhaust fan.
The input voltage must correspond (AC 230V 50/60 Hz or AC 115V 50/60 Hz) – see