Thunder Laser NOVA Series - Menu Navigation and Options

USERS MANUAL NOVA SERIES
www.thunderlaser.com DONGGUAN THUNDER LASER EQUIPMENT CO.,LTD
tech@thunderlaser.com Shatian Town, Shatian Dadao, Mintian
Tel :(86)769 826653 Dongguan City, Guangdong Province, China
45
45
MaxPower1：
%
Modified press Enter
30.0
MaxPower2：
Press Z/U move item
%
30.0
Layer0：
MinPower1：
%
22.0
MinPower2：
%
30.0
Speed：
mm/s
400
4.4.6 Menu button
The Menu button can be pressed when the system is idle or the work is finished. On
pressing this button, it will show some entries in the following interface:
 U Move: When the green block is on “U Move” item, to control the rotary
attachment to turn by pressing left and right arrow button.
 Axis Reset+: When the green block is on this item, you can manually reset the
axis if needed.
 Set default para: To recover all manufacturer parameters and user parameters
for your machine
 Auto Focus: To use the auto focus function.
 Language: The item “Language” helps you to select a appropriate langue which
is displayed on the panel:
 IP Setup: The machine is already assigned an IP address as
192.168.1.100,and the IP address on software should be the same while
communicate
 Diagnoses: the “Diagnoses” interface shows some system input information,
such as limiter status, the status of the water protecting, and the status of the
door protection etc..