USERS MANUAL NOVA SERIES
www.thunderlaser.com DONGGUAN THUNDER LASER EQUIPMENT CO.,LTD
tech@thunderlaser.com Shatian Town, Shatian Dadao, Mintian
Tel :(86)769 826653 Dongguan City, Guangdong Province, China
4.2 ON/OFF Switch
The mains and the laser supply power ON/OFF switch
The following conditions must be fulfilled for correct start up:
Unrestricted freedom of motion of the mechanics
No materials under the engraving table
Protection covers closed
When turn on the power of machine, and note that turn on the main switch first and then
the laser supply power switch
If all covers are closed, immediately after being switched on, the device starts the
referencing process. When the referencing process is completed correctly, an acoustic
signal sounds and the device is ready for operation. The operation panel will display the
home screen when the laser is completed resets.
Before switching on the device, the user must make sure that no
objects of any kind are located inside the operating space, which could
limit or obstruct the mechanics of the device.
To Next Page
Loading...
