12
RUDDER INSTALLATION
30.Locate the elevator pushrod parts as shown, epoxy the
plywood inside the wood rod at two ends with wires.
Thread the M2 nuts and clevises and make sure the whole
elevator pushrod has no free play.
31.Apply a small tube onto the clevis then connect the
elevator pushrod to the elevator torque rod links. A flat
head screwdriver will help snapping the clevises onto the
torque rod link.
32.Install elevator servo, note the servo orientation. Then
adjust the clevises to make sure elevators are level when
servo is in neuronal position.When satisfied, remove the
elevator pushrod temporarily and secure all M2 Nut and
Clevises firmly.
Rudder Installation
33.Install the rudder torque rod and glue the hinges in place
as shown.
34.CA the rudder on the vertical fin.
To Next Page
Loading...
