18
COWLING INSTALLATION
64.Secure battery box cover with four 2x8mm washer wood
screws.
65.Connect all servo wires to the receiver;wrap the receiver
with foam to fully protect the receiver.Secure the receiver
in the fuselage under the fiberglass tube or use Velcro to
fix it in place.
66.Route the antenna along the fuselage and exit at the tail
gear opening. Use Scotch Tape to tape it as shown.
67. Install the switch harness as shown.
Cowling Installation
68.Install the engine cowling;first glue the plywood doublers
inside the fuselage at the firewall where notches are
located. Trial fit the cowl in place and temporarily secure
it with mask tape. Drill 1/16" (1.5mm) at the place where
doublers are.Drill needle valve extension wire exit hole.
69. You may install precision Fueler (TTR1115) and built-in
glow plug extension wire (TTR2174) for easy fueling and
engine start,hence avoiding damaging the decal.
RX
To Next Page
Loading...
