19
COCKPIT INSTALLATION
70. File the cowling located near the vent of carburetor as
shown, the engine will get enough air and run smoother.
When satisfied, secure the cowling in place with six
2x8mm washer wood screws.
Cockpit Installation
71. Trial fit the upper fuselage cover,drill eight 1/16" (1.5mm)
holes and glue small plywood doublers inside the fuselage
at the holes area. Drill the doublers again and secure the
upper cover in place with 2x8mm washer wood screws.
72.Trim the cockpit and canopy; apply decal on the cockpit
and canopy as shown on the photo.
73. Trial fit the canopy on the cover,same procedure to glue
the plywood daubers and drill four 1/16"(1.5mm) holes.
Glue the cockpit in place and secure the canopy with four
2x5mm wood screws.You may install a pilot (Cap'n Eddie
ACE3019) to obtain a more realistic view.
74. Refer to the box label then apply all decals.The photos
shown is the decal at retract gear door.
75.Your Rare Bear is now ready to fly, carefully set up the
control throws and balance your plane well before your
first flight.Always examine everything before each and
every flight ;never take chances or rush fly your Rare Bear.
To Next Page
Loading...
