16
ENGINE INSTALLATION
Engine Installation
52. Install the anti-vibration engine mount with 5x40 mm
socket screws. Place the Engine (Thunder Tiger PRO-90
Shown) in the Engine Mount then proceed to make mount
hole marks on the engine mount where drive washer is
6"(15.2cm) to the firewall.
53.Remove the engine and engine mount.Drill 3.4mm holes
on those marks then tap the hole with M4x0.7 thread tap.
Re-install the engine mount and use M4x20mm socket
screws to secure the engine in place. Locate the z bent
throttle pushrod,and install it onto the throttle lever.
54.Install the EZ connector on the throttle servo horn with
M2 washer and M2 nut. Afterwards, thread the throttle
pushrod through the EZ connect and secure the servo
horn on the servo. Adjust the servo with the radio on,
once satisfied with the result, proceed to secure the
throttle pushrod with a 3x3mm set screw.
55.Install the Rare Bear Exclusive Muffler (TTR9791), which
contains 2 angled exhaust pipes and aim to the concavity of
the fuselage for true scale looking.
Retract Servo Installation
56. Locate the four dowels,trial fit them on the wing root first,
glue them in place with epoxy or thick CA and make sure
the dowel is at least 1/4"(8mm) in length outside the wing
root. It might need to sand the edge of dowels to achieve a
snug fit to fuselage.
57. Locate the retract servo tray, glue the doubler as shown.
Then, install the retract servo on the servo tray.
To Next Page
Loading...
