OPERATING MANUAL 2. PRODUCT DESCRIPTION
ThyssenKrupp Aufzugswerke GmbH
2.6 Motor types
The standardized THYSSEN motors for machine DAF 330 described below
correspond to constructional size B3 with pulse generator.
They are frequency-controlled.
The following versions are available:
Frequency-controlled THYSSEN motors optionally available for use :
without energy recovery (with resistor)
type DAF 330 - M 001; M 003; M 005;
with energy recovery type DAF 330 - M 002; M 004; M 006;
with rated output of: 25; 20; 17.5/16 KW
For motor data see 2.10 / 2.11
2.7 Motor connection
How to connect the motor:
Note terminal diagram on the inside of the motor terminal box and/or terminal
diagram in chapter 2.9 of this operating manual and the respective building
codes.
2.8 Pulse generator:
DAF 330 is controlled by means of an incremental hollow shaft pulse
generator mounted on the rear end of the rotor shaft. A flange-type socket
has been provided as connection to control.
For notes on installation and drawing see 7.6
Technical data for TTL generator:
Hollow shaft encoder with 2 signals with 90° phase shift and reference mark
Number of increments per rev. (Z): 16384 pulses/revolution
Supply voltage: 4...6 V
Output driver: RS 422
Max. output frequency RS 422: 300 kHz
Push-pull output: 200 kHz
Static radial movement: ± 0.5 mm
Static axial movement: ± 0.5 mm
Working temperature range: − 20...+70 °C
Storage temperature range: − 30...+85 °C
Permissible relative humidity: 70 %
Loadless working current with 5 V 120 mA
Protection class: IP 00
To Next Page
Loading...
Need help?
General