OPERATING MANUAL 9. ANNEX
ThyssenKrupp Aufzugswerke GmbH
3. Blocking clamp (for traction sheave)
1 Nib
2 Pressure plate
3 Pressure screw
4 Fastening screw
Hang nib of blocking clamp (pos. 1) in snap ring groove below brake disc.
Screw fastening screw in face side of traction sheave. Tighten pressure
screws and thus clamp ropes.
Use: for slipping ropes.
Example: disengaging the car after safety gear operation.
4. Rope grip (for rope pulley)
Fastening: insert blocking clamp between rope
pulley and frame and see to it that the lateral
inclination of the blocking clamp faces the rope
pulley. Screw in and tighten the screws (pos. A)
and thus clamp ropes.
Releasing: unscrew screws and place them onto
internal screw thread (pos. B). Screw in the
screws and release rope grip by separating rope
grip and frame C by force.
Use:
Is used for fastening the counterweight
4
2
3
1
Fig. 20
Fig. 21
C
To Next Page
Loading...
Need help?
General