OPERATING MANUAL 1. SAFETY
ThyssenKrupp Aufzugswerke GmbH
• unauthorized modification of drive (performance etc.)
• unsatisfactory supervision of parts which are subject to wear
• inexpert repair work
• catastrophes caused by outside influence and Act of God.
Constructional modifications of machine DAF 330
DAF 330 is adjusted at the factory and is delivered ready for work.
In the case of any modifications of the machine THYSSENKRUPP
AUFZUGSWERKE cannot be hold liable.
Use of DAF 330 and possible hazards
DAF 330 shall only be operated in a closed machine room and only if a rope
guard is mounted on traction sheave and on deflection pulley. Switch off
power supply and secure installation against unintended switching on before
you install the handwheel. Remove handwheel before you put installation
into service again.
See to it that the necessary safety distance to all revolving parts (marked
yellow) is observed by persons working in the machine room.
In the case of incorrect use there will be danger to life for the user or third
parties resp. impairment of the component or material property. Failures
which possibly impair the correct functioning shall be eliminated immediately.
To Next Page
Loading...
Need help?
General