MEP S.p.A.
8--2
142
Use and maintenance manual TIGER 370 CNC--MR
Maintenance requirements
H All ordinary and extraordinary maintenance must be carried out with the power
switched off and the machine in emergency condition.
H To guarantee perfect operation, all spare parts must be MEP S.p.A originals.
H On completion of maintenance works, ensure that the replaced parts or any tools
used have been removed from the machine before starting it up.
H Any behaviour not in accordance with the instructions for using the machine may
create risks for the operator.
H Therefore, read and follow all the instructions for use and maintenance of the ma-
chine and those on the product itself.
General maintenance
Daily
The daily maintenance operations to carry out on the machine are as follows:
" remove all swarf from the machine (using compressed air or preferably
t h r e a d --- f r e e c l o t h ;
" top up the lubricant/coolant fluid level;
" check the wear of the blade and change if necessary;
Weekly
The weekly maintenance operations are as follows:
" remove all swarf from the machine;
" empty the chip drawer on the side of the pedestal;
" clean the vice and lubricate all the joints and sliding surfaces using a good
quality oil;
" check the oil level in the drive box: if necessary top up through the filler cap;
" Check the cutting clamp slide, if it is not precise or there is sideways move-
ment, regulate as indicated in chapter 7.
To Next Page
Loading...
General