5--5
30
Description of machine operation
However, to ensure that the workpiece is securely clamped in the vice, proceed as
follows:
" make sure the workpiece dimensions do not exceed the machine’s cutting ca-
pacity;
" make sure the piece is correctly supported on both sides of the machine;
" move the vice to within 2÷3 mm of the workpiece using the handwheel. Press
the vice closure button on the console;
2-- 3 mm
" make sure that the material is well blocked by trying to move it manually, as
thevicecylinderhasastrokeof6mmonly.
To Next Page