6
Key for control console keyboard 5--1................
Basic instructions for carrying out a cutting cycle 5-- 4...
Manoeuvring the cutting head 5-- 4...................
Access to the cutting head 5--4......................
Manoeuvring the feeder 5--4........................
Clamping the work piece in the vice 5-- 4..............
Lubricant/coolant fluid supply 5--6...................
Preliminary check list for cutting operation 5--6........
Starting up the machine 5--7........................
Semi--automatic operating cycle 5--8.................
Automatic operating cycle 5-- 12......................
Single program 5--15...............................
Multiple programming 5--22.........................
Multiple programming cuts 5--29.....................
Automatic loop operating cycle 5-- 30..................
Diagrams, exploded views and replace--
ment parts 6--1...................................
Pneumatic diagram TI GER 370 CNC--MR 6--1.........
Pneumatic diagram TI GER 370 CNC--FE HR 6--2......
APS/P drive for step motors 6--3....................
MEANING OF THE PARAMETERS IN THE TABLE 6 --3
SCHEMATIC CONFIGURATION
OF INPUTS / OUTPUTS 6--7......................
LAYOUT OF APS/P DRIVE COMPONENTS 6--8.....
How to read the wiring diagrams 6--9.................
D2--Letter codes used to designate the type
of component 6--11................................
Standardised Wiring Diagrams TIGER 370 CNC--MR
(IEC 750 EN 60204--1 Standard) 6--14.................
List of cables 6--29................................
List of components 6--34............................
List of terminals 6--37..............................
List of IUD--IUV Card Inputs and Outputs 6--39.........
IUD: Digital Inputs and Outputs 6--39.................
IUV card: Miscellaneous Inputs and Outputs 6--39.......
CN 1 VICE 6--40..................................
CNSL card: Console Inputs and Outputs 6--41...........
Exploded views 6--42..............................
To Next Page
Loading...
General