MEP S.p.A.
5--32
57
Use and maintenance manual TIGER 370 CNC--MR
" All that remains to be done, is that the sequence of execution of cutting pro-
grammes is to be established. Key in the programme numbers, to correspond
to the letters, confirming each one by pressing ENTER.
ABCDEFGH
1 12 16 17 18 20 23 21
IJKLMNOP
29 30
QRSTUVWZ
AA BB CC DD EE FF GG HH
LOOP NR. = 99
" Also key in the number of LOOPS if using a continuous work cycle. Press
RUN/PROG. to proceed.
" The display screen will show the parameters of the first program set. Pressing
START the machine is reset and performs the initial cut before starting the
LOOP. Then the supply unit places the material of the length set in the first
program and the head descends to execute the cut. PROGRAMMING FCTA
will appear on the display. Once the cutting depth has been reached, reset the
head downstroke regulator by stopping the cutting head stroke; then press the
Head Downstroke Limit (FCTA) memorizing button.
" Memorise the cut depth for the second programme and so on for all pro-
grammes selected. On completion of this operation the user can select wheth-
er the cuts should be carried out in single or continuous mode, by pressing F7.
To Next Page