STEERING COLUMN, OPERATOR'S GRIP, CABINET AND AIR SWITCHES.
12
Used, among other things, on the sweep/suction system to adjust the rotation speed of
the brushes.
9. Light switch. Step 1 position light - Step 2 headlight
10. Cruise control.
When the desired travel speed is achieved with the accelerator, the switch is activated
and this speed is maintained. The function is deactivated by pressing the switch, by
activating the brake pedal or by activating the direction selector on the accelerator.
11. Cup holder and holders for mobile phone and ballpoint pen.
12. Air fan regulator.
The fan control has 4 steps, from 0 to 3. If there is a lot of dew on the windows and the
fan is set to step 3, it may be advantageous to open the side window slightly to quickly
get rid of large amounts of moist air.
13. Heat supply regulator.
14. Air conditioning on/off.
15. Regulation of air conditioning.
Note that the fan must be set to at least step 1 to switch on the air conditioner. The air
conditioning can be used to dehumidify the windows in winter. Set the cooling control
to the minimum and the heating control to the maximum. Dehumidified air will then
enter the cabin, and the dew on the window panes is quickly removed.
16. USB Plug with constant power.
17. Switch 12V reversible S70 (Legs no. 8 and 9 in 13 pole connectors)
Used, for example, to regulate the spreading speed of the roller spreader if it is
electrically controlled.
18. The rear PTO is only switched on when the machine is moving forward.
Used, among other things, in conjunction with roller applicator so that it starts and
stops in step with the progress of the machine.
19. Switch for rear PTO.
Note: It is not possible to start the machine if this switch is activated. Turn on with
common PTO [1]
20. Switch 12V reversible S72 (pin no. 11 and 12 in 13 pole connectors).
Used, for example, to regulate the application quantity of the roller spreader if it is
electrically controlled.
21. Switch for the bidirectional hydraulic jack at the rear of the machine. Used, among
other things, to raise and lower the tipper.
22. Contact 12V in trailer socket.
Used to turn on/off the water on the front broom and tank when the sweep suction is
used. This switch turns on and off together with common start [1]
To Next Page
Loading...