MAINTENANCE DATA
25
8. MAINTENANCE DATA
This section contains data regarding maintenance of the machine.
8.1 Hydraulic oil
Standard: Shell Tellus S3 V 46
Optional (Factory only) ELF Biohydran TMP 46
Top up with the type of oil filled from the factory. If you want to refill with another brand,
contact the manufacturer in terms of miscibility.
The level is checked as shown in the video regarding daily maintenance.
8.2 Coolant
From the factory, the cooler is filled with a mixture of water and antifreeze. Mixing of water
and antifreeze must be done before filling.
Antifreeze type: Ethylene glycol
Mixing ratio: 50% water, 50% antifreeze
Freezing point (50/50): -37 ° C
8.3 Lubrication
When lubricating, it is recommended to use NLGI-2 type grease
See lubrication plan in video regarding lubrication.
8.4 Engine oil
From the factory, the engine is filled with engine oil Texaco Delo 400 XLE SAE 10W-30
semi-synthetic.
If you want to top up with another brand, first check the miscibility with that brand.
Oil type: Texaco Delo 400 XLE SAE 10W-30
API: Better than SL
8.5 Air conditioning
Type: R134a
Quantity: 380 g.
8.6 Wheels
Tire pressure must be regulated in relation to the load on the machine. With increased weight,
the tire pressure must also increase.
Tire pressure for factory setting: 1.8 bar
Tire pressure behind factory setting: 2.0 bar
Tire pressure maximum pressure: 2.75 bar
Tightening torque wheel nuts: 100 Nm
To Next Page
Loading...