Timberwolf TPS35 - DAILY MAINTENANCE; ASH DISPOSAL AND BURN POT INSPECTION; GLASS CARE

W415-0865 / B / 05.26.11
33
THE FRONT OF THE APPLIANCE BECOMES VERY HOT DURING OPERATION. LET THE APPLIANCE
COOL COMPLETELY BEFORE CONDUCTING SERVICE.
!
WARNING
10.0 MAINTENANCE
10.1 DAILY (WHENEVER USING THE APPLIANCE)
10.1.2 INSPECT THE BURN POT
10.1.3 CARE OF GLASS
40.2
Ashes should be placed in a metal container with a tight fi tting lid. The container should be placed on a non-
combustible fl oor, well away from combustible materials, pending fi nal disposal. If ashes are disposed of by burial
in soil or otherwise locally dispersed, they should be retained in the closed container until all cinders are thoroughly
cooled.
When burning, the fl ames should be bright orange with embers jumping from the
burn pot. If not see “MAKE SURE PELLETS ARE NOT PILING UP” or “CLEANING
THE BURNPOT” sections.
40.3A
10.1.1 DISPOSAL OF ASHES
If the glass is not kept clean permanent discolouration and / or
blemishes may result. Normal operation of your pellet appliance
will produce a build-up on the glass that should be wiped off
daily. However, poor quality pellets or extended burning on the
low setting will cause the glass to “smoke up” faster.
Refer to “REPLACEMENT PARTS” section to fi nd out what this
product is equipped with. Use only replacement glass available
from your Authorized dealer.
DO NOT CLEAN GLASS WHEN HOT!
If necessary, clean the glass with a soft cloth or paper towel. You could use “wood stove” glass cleaner to
remove heavy build-up.
Do not operate the appliance with broken glass, as leakage of fl ue gases may result.
5.2
HOT GLASS WILL
CAUSE BURNS.
DO NOT TOUCH GLASS
UNTIL COOLED.
NEVER ALLOW CHILDREN
TO TOUCH GLASS.
!
WARNING