TIME MARK TMC430 - Page 17

Page 17 of 41
Rev: 2024-10-03
35) Press Enter to lock in the value
36) Press Next to continue to the CONFIG – ALARM ENABLE selection
37) The CONFIG – ALARM ENABLE screen presents the following:
• Seal Fail = ON
• Over Temp = ON
• Contactor = ON
• Spare = OFF
These affect the switch inputs for all pumps, and the default values are
shown.
All four alarms will activate the alarm relay, however, only the “Contactor” will
disable the pump when activated.
38) Press Selct when the selection arrows are next to the option you want to change
39) Use the + and – keys to adjust the value from ON to OFF or OFF to ON
40) Press Enter to lock in the choice
41) Repeat steps 38 to 40 until the settings match your needs
42) Press Enter to lock in the value
43) Press Next to continue to the FLOAT ERR CORRECTION screen (if the 4-20
input option was selected, this menu will be skipped)
44) The FLOAT ERR CORRECTION screen selection is either OFF or ON (this
setting allows the controller to correct should the floats activate out of sequence)
45) Use the ↑ or ↓ keys to move the selection arrows to the selection of choice and
press Selct
46) Press Next to lock in the value and proceed to the CONFIG – PUMP
ALTERNATE setting
47) Press Next to continue to the CONFIG – PUMP ALTERNATE screen
48) The CONFIG – PUMP ALTERNATE screen presents the following:
• Pump 1 Lead
• Pump 2 Lead
• Pump 3 Led
•
•
• Alternate Pumps
The number of pumps shown will depend on the number of pumps selected in
the first pump configuration screen. “Alternate pumps” will switch the lead
pump after each “Lead pump” activation to allow for equal amounts of run
time per pump.
49) Use the ↑ or ↓ keys to move the selection arrows to the selection of choice and
press Selct
50) Press Next to lock in the choice and proceed to RESET ON CONT FAIL setting