TIME MARK TMC430 - Time and Date Setting; Password Selection

Page 19 of 41
Rev: 2024-10-03
67) Press Exit to return to the CONFIG – SYSTEM screen
68) Press Exit a second time to return to the normal run screen (Figure 8)
6.2.1 Time and Date Setting
1) Press Selct when the selection arrows are pointing to the “Time/Date” option
2) Two choices will be presented:
• Time hh:mm:ss
• Date mm.dd.yy
3) Press Exit to return to the CONFIG – SYSTEM screen
4) Press Exit a second time to return to the normal run screen (Figure 8)
6.2.1.1 Time Setting
1) Press Selct while the selection arrows are pointing to the “Time” option
2) Use the + and – keys to adjust the hours; note this is a 24-hour format (0 to 23)
3) Press Next to advance to the minutes
4) Use the + and – keys to adjust the minutes
5) Press Next to advance to the seconds
6) Use the + and – keys to adjust the seconds
7) Press Enter to lock in the value and leave the time adjustment mode
6.2.1.2 Date Setting
8) Press Selct while the selection arrows are pointing to the “Date” option
9) Use the + and – keys to adjust the month (1 to 12)
10) Press Next to advance to the date of the month
11) Use the + and – keys to adjust the date of the month
12) Press Next to advance to the year
13) Use the + and – keys to adjust the year
• The model TMC430 uses a 2-digit year
14) Press Enter to lock in the value and leave the date adjustment mode
6.2.2 Password Selection
Note: if the Password is turned ON and a password other than 0000 is entered, the
password will be required to enter the CONFIG screen in future.
1) Press ↓ until the selection arrows are pointing to the “Password OFF” option
and then press Select
2) The SYSTEM – PASSWORD screen presents two choices:
• OFF
• ON
3) If ON is selected, the password digits will be presented and using the + and –
keys, each digit may be adjusted from 0 to 9.
69) Press Exit to return to the CONFIG – SYSTEM screen
70) Press Exit a second time to return to the normal run screen (Figure 8)