Tissue-Tek TEC 5100 - Table of Contents

Revised 07/12/11 iii
Section Page
1 INTRODUCTION
General Description .......................................................................1.1
Features ...................................................................................1.1
Operation: Warm Up and Ready Times ....................................................1.2
Specifications .............................................................................1.3
2 UNPACKING, SYSTEM DESCRIPTION
Unpacking ................................................................................2.1
Carton Contents ...........................................................................2.1
System Description
Embedding Module (Front Panel) .......................................................2.2
Embedding Module (Back Panel) .......................................................2.3
Accessories .............................................................................2.4
Embedding Module (Control Panel) .....................................................2.5
Cryo Module (Front Panel)..............................................................2.7
Cryo Module (Back Panel) ..............................................................2.7
Audible Alarms .........................................................................2.7
3 SET UP
Installation ................................................................................3.1
Attach Magnifying Lens Assembly ........................................................3.2
Verify Proper Installation/System Functioning/Power On...................................3.3
Access Set Up Mode ......................................................................3.4
Set Day and Time .........................................................................3.4
Set Cryo Module Mode of Operation ......................................................3.4
Input Cryo Offset Valve ...................................................................3.4
Change or View Set Temperatures .........................................................3.5
Add Paraffin...............................................................................3.6
Place Base Molds into Chamber ...........................................................3.6
What Happens When Power Is Turned Off.................................................3.7
When To Set Power Switches On Front Panel To Off ......................................3.7
4 AUTOMATIC TIMER (OPTIONAL USE)
EMBEDDING MODULE
ON and OFF Times for Selected Days of the Week.........................................4.1
Setting the Automatic Timer ...............................................................4.1
Checking the Status of the Automatic Timer (What Time is Set?)...........................4.2
5 EMBEDDING PROCEDURE
Embedding Procedure (example) ..........................................................5.1
TABLE OF CONTENTS