Titan Electronics USB-2CAN-M - Setting CAN Bitrate

20
8.3.1 Opening the CAN Bus Channel
The CAN bus channel will be opened with the command O[CR], L[CR] or Y[CR]. The
command O[CR] will open the CAN bus channel in normal operation mode, the
command L[CR] will open the CAN bus channel in listen only mode, in which no bus
interaction will be done from the controller. the command Y[CR] will open the CAN
bus channel in a loop-back mode, in which the USB to CAN adapter will also receive
the frames that it sends. Before you use one of the commands, you should set a bitrate
with the commands S or s.
Command
Response
Function
O[CR]
[CR]
Open the channel in Normal mode
L[CR]
[CR]
Open the channel in Listen Only mode
Y[CR]
[CR]
Open the channel in Loopback mode
8.3.2 Closing the CAN Bus Channel
The CAN bus channel will be closed with the command C[CR]. The command can only
be used if the CAN bus channel is open.
Command
Response
Function
C[CR]
[CR]
Close the CAN channel if it is opened