Tks Operator’s manual
4
Guarantee
TKS products carry warranty for a period of one year from the date of delivery, against defects in
material and workmanship.
Components not manufactured by TKS. electrical and hydraulic, PTO shafts and tyres are
guaranteed according to the original manufacturer’s recommendation.
The components listed below have a limited warranty due to their function:
• Tyres
• Pre-stretcher rollers
• Fuses
• Hydraulic seals of motors, valves and cylinders
• Oil fi lter
• Chain
• Sprocket
• Web
Weakening due to wear and tear is considered to be normal for these parts. The product
guarantees for these components are limited to manufacturing defects, breakage, poor
workmanship, transport damage etc on new machines.
Any damage to bearings that are fi tted with grease nipples is not covered under the standard
product guarantee, if the damage is shown to be caused by rust or due to the ingress of liquids.
Such damage is caused by insuffi cient lubrication or the use of low quality lubricants.
Any damage caused by the use of corrosive additives in or nearby the machine is also not
covered.
If a failure is expected to be covered under the guarantee, the owner or its representative should
inform the dealer when parts and/or repair work is required. Any guarantee claim should be applied
for within the period of guarantee.
The dealer should fi ll in one guarantee claim form for each matter and forward it to the TKS
representative before the 10th of the following month after the claim was raised.
The damaged parts should be marked with the number of the corresponding warranty claim and
should be stored for 6 months by the dealer, available for inspection by the TKS representative if
required.
Due to the operation of the TKS products being out of the manufacturer’s control, the guarantee
covers the product quality only. Performance or any consequential losses are not covered.
The guarantee may be invalid if:
a) spurious spare parts are used or the product is repaired or modifi ed without the
TKS authorisation.
b) operator’s and service instructions given by the manufacturer are not complied with.
c) the machine is used for other purposes than those designed for.
d) The damage occurs as a result of external faces such as high voltage fl uctuations due
to a low supply voltage, lightening or other electrical phenomena.
The guarantee does not cover damage caused by normal wear.
Public safety regulations require from the manufacturer of this machine that all safety aspects
regarding the use of the machine is thoroughly evaluated. As a result of these obligations TKS and
its representative are not responsible for the function of components not shown in the spare parts
catalogue covering this product.
TKS reserve the right to change the product with no obligation to previously supplied machines.
NB! It must be possible to identify all enquiries relating to this product’s serial number; see page 7
Machine identifi cation.
To Next Page
Loading...