To Next Page

To Previous Page

Compact IP Codec User's Manual

Techno Mathematical Co., Ltd.

2140P

Buffer Size Setting

If the sequence of packets which the decoder received is changed, the packet

sequence is rearranged into proper sequence in the buffer and then decoded. This

setting is valid in an environment where packet sequence switching is performed.

Configure the settings below.

Table 7-2 Decoder – Buffer Size Setting

Setting Description Initial

Default

Buffer Size Setting 0/20/40/70/100/140/170/200/300/400/500msec 0msec

Figure 7-2 Decoder – Buffer Size Setting

■ Start up DECODER.

■ On the Detail Setting tab, configure

setting in the [Buffer Size Setting] group.

The larger the setting value, the greater the range over which packet sequence can

be rearranged, but a larger value also increases latency.

Questions and Answers:

Need help?

Do you have a question about the TMC TM7006E and is the answer not in the manual?

TMC TM7006E Specifications

General