Compact IP Codec User's Manual
51
Techno Mathematical Co., Ltd.
2140P
Error Correction Settings
Transmission of redundant packets for error correction is used for packet correction
when packet loss occurs. This setting is valid in an environment where packet loss
occurs.
Configure the settings below.
Table 7-3 Decoder – Error Correction Setting
Setting Description Initial
Default
None Redundant packets for error correction not
transmitted.
None
x1.5 Redundant packets for error correction transmitted in
a volume that is half of the transmission rate.
x2.0 Redundant packets for error correction transmitted in
a volume that is the same as the transmission rate.
Pro-MPEG
(Dim1)
Tolerant redundant packets for error correction
transmitted in a burst packet loss.
Pro-MPEG
(Dim2)
Tolerant redundant packets for error correction
transmitted in a burst random packet loss.
Pro-MPEG
matrix
size
cols The number of restored burst packet losses (1-32).
As this value becomes higher, tolerant for
burst packet
loss
is increased.
4
rows
The rate of the redundant packet (1-32)
As this value is smaller, the rate of the redundant
packet becomes so a lot.
4
Figure 7-3 Decoder – Error Correction
■ Start up DECODER.
■ On the Detail Setting tab, configure the
setting in the [Error Correction] group.
To Next Page
Loading...
Need help?
General