Chapter 5: OPERATION
2. EMERGENCY BROADCASTS
5-17
Step 4. Reset the emergency broadcast mode.
Press the Emergency Reset key
.
After the Reset EV message has been broadcast to the
entire area, the system is restored to general-purpose
broadcast mode.
Note
The Reset EV message is broadcast only to the zones to
which the emergency EV broadcast was made.
The Emergency Activation button light extinguishes to
indicate that the system is in general-purpose broadcast
mode.
3
Emergency Reset key
Unused
Tip
When a Fireman's Microphone announcement interrupts an EV message broadcast, the broadcast mode that
follows Fireman's Microphone announcement completion can be set to either "Continue" for continuous EV
message broadcast or "Silent" for broadcast termination. This setting can be made by way of the connected
PC. For details, refer to p. 7-40.
Microphone LED
Microphone Enable LED
5
Talk key
Lights
3F
•Because the Alert EV message is currently being
broadcast, the left-side Microphone Enable LED flashes
green, indicating that broadcasts with priority lower than
that of microphone announcements are in progress.
•The right-side LED indicates the status of microphone
usage. It lights green when the Talk key is pressed.
•SpeakingintothemicrophoneafterpressingtheTalkkey
causes the Microphone LED to light green and permits
announcements to go through to 3F.
•The Zone Monitor LED of the 3F Zone Select key
lights green when announcements are made from the
microphone.
Select LED
3F Zone Select key
Zone Monitor LED
Lights
9
To Next Page
Loading...
