26
6. Brief Introduction of Sleep Function
When there is no paper feeding, no data received and no operation in
three minutes, the printer will be in sleep mode to reduce the power
consumption. At this moment, only the indicator light of the power will
blink and other indicator lights will go out. However, the printing data
can still be received if connecting to the printer via USB, the computer
will down send the print job to awake the printer automatically, and then
the printer begins to work.
In sleep mode, if need to use WIFI printing or configure IP address,
press any buttons on the operation panel to manually awake the printer
(the duration for pressing the power button can’t exceed one second,
otherwise the printer will be turned off), and wait for about 5 seconds till
the indicator light returns to normal, that is to say, the machine returns
to the state of preparing for printing.
The duration for sleeping can be configured by software. The methods
are shown as follows:
1.Click the operation panel in the start menu, select “Printer and other
hardware”, select the portable printer in the “Printer and fax” folder,
right click the printer attribute, and the dialog box of “OEP103W
attribute” will pop up.
2. Click the tab “Printer setup”, select
the suitable sleep time in the pull-down
list of “ Sleep time”, and click “ Save” .
To Next Page
Loading...