TOHATSU MFS 8A3 Owner's Manual

ENGINE OPERATION50
7
ENON00921-0
Note
Before tilting the outboard motor up, after
stopping the motor leave it in the running
position for about a minute to allow water to
drain from inside the engine.
ENOM00062-A
Manual Tilt type
Tilt up
With the shift lever in Neutral or Forward,
fully tilt the motor up toward you by hold-
ing the tilt handle provide at the rear of the
top cowl. Then slightly lower the motor for
locking in the up position.
1. Tilt lever
2. Tilt up position
3. Shalow water operating position
ENOM00063-A
Tilt down
Slightly tilt the motor up, and pull the tilt
lever toward you to release the tilt-lock.
Then lower the motor slowly.
1. Tilt down position
2. Tilt up position
3. Reverse lock lever
ENOM00069-B
Power Tilt type
Tilt up
1. Operate the Power Tilt switch and tilt
the outboard motor up.
2. Lock the tilt with the Tilt stopper after
the outboard motor has been tilted up
Tilt down
1. Release the tilt stopper from the set-up
position while slightly tilting up out-
board motor.
2. Operate the Power Tilt switch and tilt
the outboard motor down until the
motor touches to the thrust rod.
N
ENOF00543-0
1
2
3
ENOF00544-0
ENOF00545-0
0)6$B(85B(1B1ERRN࣮࣌ࢪ㸰㸮㸯㸲ᖺ㸯㸰᭶㸯㸱᪥ࠉᅵ᭙᪥ࠉ༗ᚋ㸳󰪍㸲㸷ศ

TOHATSU MFS 8A3 Specifications

General

Brand	TOHATSU
Model	MFS 8A3
Category	Outboard Motor
Language	English