Tohnichi DOTE4-G - External Data Output; Printer Output

17
DIGITAL TORQUE WRENCH TESTER DOTE4-G
8. External Output Function
8-1. Printer Output
Connect the DOTE4-G and the Tohnichi printer (EPP16M3) using a printer cable
(Catalog No. 382). Set the communication output format to “Prn” and ensure that
other communication settings are consistent with the printer.
See “5 Various Settings” for the setting methods.
* Do not use a printer cable and a USB communication cable at the same time.
• Communication settings for the EPP16M3
Data format
Transmission system
Baud rate
Data length
Stop bit
Parity
: RS232C-compliant
: Start-stop synchronization serial
: 2400 bps
: 7 bits
: 1 bit
: None
(1) Progressive printing
Press the "Memory/Reset" button. In the progressive printing, the results of statistical processing
are not printed. In the Auto Memory/Reset mode, the results are automatically printed out.
(2) Continuous printing
Display the last count value in the print range and press "STAT" key. “Stt” is displayed.
Using ▲ or ▼ key, display the rst count value in the print range and press "STAT" key.
Then, press ▲ key while “n” is displayed.
The data, sampling number “n”, maximum value “HI”, minimum value “LO” and
average value “X” in the specied range are printed out.
(3) Printing of only statistical processing value
Display the last count value in the print range and press "STAT" key. “Stt” is displayed.
Using ▲ or ▼ key, display the rst count value in the print range and
press the "STAT" key. Then, press ▼ key while “n” is displayed.
The sampling number “n”, maximum value “HI”, minimum value “LO” and
average value “X” in the specied range are printed out.