9
The route is calculated by your device using IQ Routes
TM
.
IQ Routes is used to plan the best possible route taking into account the real
average speeds measured on the roads.
9. When the route has been calculated, tap Done.
Your TomTom GO navigation device will warn you about any traffic delays
and immediately begin to guide you to your destination, using both spoken
instructions and on-screen directions.
Using your voice to plan a route
Instead of tapping the screen you plan a route, you can use your voice to plan
a route.
For information about the different ways you can plan a route using your
voice, see Voice control.
Arrival times
When you plan a route, your TomTom GO asks you if you need to arrive at a
particular time.
Tap YES to enter a preferred arrival time.
Your GO calculates your arrival time and shows you whether you will arrive
on time.
You can also use this information to work out when you need to leave. If your
GO shows that you will arrive 30 minutes early, you can wait and leave in 30
minutes time, rather than arrive early.
Your arrival time is constantly recalculated during your journey. The status bar
shows whether you will arrive on time or if you are going to be late, as shown
below:
You will arrive 55 minutes before the arrival time you entered.
If the estimated arrival time is more than five minutes before
the time you entered, it is shown in green.
You will arrive 3 minutes before the arrival time you entered.
If the estimated arrival time is less than 5 minutes before the
time you entered, it is shown in yellow.
You will arrive 19 minutes late.
If the estimated arrival time is later than the time you entered,
it is shown in red.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
