@ToolkiRC 2021
5. Input MaxVoltage
When the discharge mode is selected to recycle, the
battery setting interface will increase the input Max
Voltage setting. Move the cursor to [Input MaxVol] and
press [OK] to adjust the input Max voltage. If the input
voltage reaches this voltage value during discharge, the
discharge will stop. As shown below:
===================================
Tips:
Please set the input Max voltage to the highest
protection voltage of the power supply. After the voltage
is reached, the charger will automatically stop recycling
discharging. Setting high overvoltage may damage the
input power
===================================
To Next Page
Loading...
