Topcon BM-7AC - Page 35

2. Measurement Operation
33
14 The correction factor is calculated and the following screen is displayed.
15 When "SET" is displayed on the following screen by pressing the [CHANGE] button,
indicates that the correction factor has been set.
16 After returning to the function mode, the correction factor becomes valid.
Entering to the Function Mode
☞
「3.1.1 Entering /Returning from the Function Mode」
Ｋ１１ ＫＸ＝ ９．３４３Ｅ-０１
ＫＹ＝ ９．５８９Ｅ-０１
ＫＺ＝ ９．３９６Ｅ-０１
Ｃ＝ＳＥＴ Ｒ＝ＮＥＸＴ Ｓ＝ＰＡＧＥ
Ｋ１１ ＫＸ＝ ９．３４３Ｅ-０１
ＳＥＴ ＫＹ＝ ９．５８９Ｅ-０１
ＫＺ＝ ９．３９６Ｅ-０１
Ｃ＝ＳＥＴ Ｒ＝ＮＥＸＴ Ｓ＝ＰＡＧＥ