56
Other Procedures
16. Changing the Settings
You can change settings such as the measuring mode and the number
of decimals in displayed data.
When you select "Config." in menu mode, the two-page configuration
menu is displayed.
16.1 Measuring Mode
You can select any of the following measuring modes.
Page 1
* Single: The instrument automatically terminates fine
measurement after taking one reading.
Average: Displays the average value calculated from the
number of times fine measurement is repeated.
(Repeat default setting: 5 times, Repeat setting
range: 2 to 9 times.)
Page 1
• Meas. (measuring mode)
• Display (fractional/decimal
representation of height units)
• Adjust (checks and adjustment)
• RS-232C (communication
parameters)
Page 2
• Auto-off (auto power-off)
• Unit (unit of measurement)
• Press to toggle between the pages.
• Asterisks (*) indicate factory settings.
• Settings are kept in memory after power-off.
• "19.2 Adjusting the Reticle" for the check and adjustment
procedure.
Notes:
DL502-503.book 56 ページ ２０１０年４月５日 月曜日 午前９時４７分
To Next Page
Loading...
Need help?
General
