EasyManuals Logo

Topcon DL-502 User Manual

Topcon DL-502
86 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #64 background imageLoading...
Page #64 background image
Other Procedures
63
18. Charging the Battery
1 Connect the power cable to the CDC68 charger and plug the
charger into the wall outlet.
2 Mount the battery (BDC46B) in the charger (CDC68) matching the
groove on the battery with the guides on the charger.
When charging starts, the lamp starts blinking.
Do not short circuit. Heat or ignition could result.
Batteries cannot be charged, even when the charging lamp is
flashing, when the temperature is outside the charging
temperature range.
Do not leave the battery anywhere exposed to high
temperatures. Battery life may be reduced.
Charge the battery once a month to maintain its quality when not
in use for long periods.
Do not charge the battery just after charging is completed.
Battery performance may decline.
Do not use to charge batteries other than those specified.
If you allow the battery level to get too low, the battery may not be
rechargeable or operating time may decline. Keep the battery
always charged.
The charger will get rather hot while in use. This is normal.
Important:
Procedure
DL502-503.book 63 ページ 2010年4月5日 月曜日 午前9時47分

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Topcon DL-502 and is the answer not in the manual?

Topcon DL-502 Specifications

General IconGeneral
BrandTopcon
ModelDL-502
CategoryLaser Level
LanguageEnglish

Related product manuals