Ap C Warnings and Regulatory Information 93
Radio Frequency Safety
This device has been evaluated for use in close proximity
to the body. Use only accessories approved by Topcon
Positioning Systems. The use of third party accessories
may not comply with FCC and international RF exposure
requirements. To comply with FCC and other national RF
exposure requirements do not co-locate this device with
other transmitters.
This device operates in compliance with the FCC radio
frequency exposure limits for an uncontrolled environment.
Users must follow instructions provided in the user
documentation to satisfy compliance with FCC radio
frequency exposure requirements.
There cannot be any alteration to the authorized antenna
system.
CE Marking (European Union)
Products bearing the CE marking comply with the
2004/108/EC (EMC Directive), 1999/5/EC (R&TTE
Directive), 2006/95/EC (Low Voltage Directive) issued by the
Commission of the European Community.
CE compliance of this device is valid only if powered
with/by a CE-marked wall charger provided by the
manufacturer. Cables connecting to the USB host port must
use a ferrite core/bead on the cable. The ferrite core must
be placed on the cable near the end that connects to the
FC-500. This device has been evaluated using the following
standards to demonstrate compliance with applicable
directives:
EN 60950-1:2006
IEC 62209-2 Ed. 1.0
IEEE Std. C95.1-1999
EN 301 489-1 V1.8.1
EN 301 489-7 V1.3.1
EN 301 489-17 V2.1.1
EN 300 328 V1.7.1
EN 301 511 V9.0.2
To Next Page
Loading...
