P/N 7010-0935
2-1
Pre-setup Preparation
Successful deployment and operation of a Reference Station system
with the Net-G3A receiver requires careful site planning, feasibility
studies, and proper equipment configuration. These factors are critical
to maximize the performance of the Net-G3A and to seamlessly
integrate the receiver into an existing network or in establishing a new
network.
Once a location for the Net-G3A has been determined, you can begin
installing the hardware and software required to configure and
maintain the Net-G3A. After determining the application, use the
selected software to configure the receiver for your application.
Finally, collect almanacs and ephemerides to begin working with the
Net-G3A in its intended application. The following sections describe
these steps in detail:
• “Determining the Reference Station Site” on page 2-2
• “Installing Topcon Software” on page 2-5
• “Installing the CF Card” on page 2-8
• “Installing the USB Mass Storage Device (UMS)” on page 2-9
• “Powering the Receiver” on page 2-11
• “Charging the Backup Batteries” on page 2-13
• “Collecting Almanacs and Ephemerides” on page 2-14
• “Connecting the Receiver and a Computer” on page 2-15
• “Power Management” on page 2-24
Net-G3A_OM_Book.book Page 1 Thursday, May 14, 2009 8:49 AM
To Next Page
Loading...
Need help?
General
