Net-G3A Configuration and Setup
NET-G3A Operator’s Manual
3-18
Using the Web Interface
The Net-G3A includes a built-in Web server that allows you to
configure and monitor the receiver via a Web user interface (or Web
interface). The following Web browsers are recommended for
accessing the receiver:
• Windows Internet Explorer 6.0 or later
• Mozilla Firefox 2.0 or later
• Opera 9.0 or later
The built-in Web server and Web interface use HTTP/HTTPS
protocols for communication.
Accessing the Net-G3A through the
Web Interface
Before accessing the Net-G3A using the Web interface, determine
whether the valid network parameters (IP address, gateway, etc.) are
specified in the receiver. Refer to “Configuring an Ethernet
Connection Using PC-CDU” on page 2-19 for details regarding the
network parameters.
1. Open a recommended Web browser.
The browser window appears.
2. In the Address or Location bar of the Web browser, type one of
the following addresses:
http://ipaddress<:port number>
or
https://ipaddress<:port number> (if SSL is enabled)
where ipaddress is the receiver’s IP address; port number is the
port number you should specify if set to a number other than the
default port number (port 80 for HTTP, and port 443 for HTTPS).
Net-G3A_OM_Book.book Page 18 Thursday, May 14, 2009 8:49 AM
To Next Page
Loading...
Need help?
General
