Configuring the Receiver
P/N 7010-0935
3-3
2. Start PC-CDU, and connect to the receiver according to the
settings described in “PC-CDU Connection Parameters” on
page 2-22.
Once a PC-CDU connection with the receiver has been
established, the current communications settings—such as port
name, baud rate (if applicable), and flow control (if applicable)—
display in the lower-left corner of the main window of PC-CDU.
A timer begins to count up in the lower-right corner as well
(Figure 3-1).
Figure 3-1. PC-CDU Connection Established
3. Click ConfigurationReceiver.
Click Apply after making any configuration
change; otherwise, the receiver will not register the
change.
Net-G3A_OM_Book.book Page 3 Thursday, May 14, 2009 8:49 AM
To Next Page
Loading...
