22
1) The working range of the remote controller is up to a distance of about 300 m from
the instrument.
2) It is necessary to install batteries when using the remote controller. Install the
batteries by referring to “How to Replace the RC-400 Batteries” on page 41.
3) The power of the remote controller shuts off automatically after about 60 seconds
when key or leveling operations have been completed (Auto-Cut Off Function).
Press the power switch once to restore power to the remote controller after the auto-
cut off function has been activated.
Common use of RC-400 remote controller
RC-400 remote controller can control plural RL-200 2S. When you are using plural RL-200 2S
at your job site, you can use your RC-400 for the other RL-200 2S unit. Change the channel to
receive the internal data of each RL-200 2S to the RC-400 by operating the RC-400.
This function enables operating of each RL-200 2S, by transmitting and displaying the data of
each unit to the remote controller before operation.
See page 33 for the operation “3) Setting channel”.
The RC-400 can also control plural RL-100 2S.
To Next Page
Loading...
