23
3 To stop scanning, remove target from beam path.
Continuous scan (Scan width can be "Drawn" and held for "Hands free" opera-
tion)
Place target in beam path and hold for a moment. The scanning beam will hesitate, then
start again. When the target is removed the beam will hold that scan automatically.
To change the scanning width, move the target left or right after the scan hesitates and the
scanning width will increase.
To cancel the "Drawn" scan simply:
Place the target for more than one second into the scanning laser beam again.
Note
• The target must be in the upright position for horizontal scanning use (magnet
on top).
Scanning hesitates
and starts again.
Move the target left or right with-
in scanning, the scanning width
changes. The scan continues
without target for hands free
scan operation.
To Next Page
Loading...
Need help?
General
