7. STANDARD ACCESSORIES
45
The RC-200 allows you to remotely control most function of the TP-L5 as shown below.
The RC-200 is convenient for aligning the beam while using a transit, or for saving power by
temporarily putting the unit in standby mode using the ON/OFF switch.
7.3 Remote Controller (RC-200)
Signal aperture
Automatic alignment mode key
Automatic centering
Laser right/left key
Laser beam mode key
Signal lamp
Laser right/left key
Laser ON/OFF switch
Press both keys at the same time
When red LED is blinking, the signal is
transmitting
Controls laser ON/OFF for
the instrument
To Next Page
Loading...
