Topcon TP-L5 SERIES - Changing Parameter Settings

8. CHANGING OPERATING PARAMETERS
53
EXAMPLE
Change R-TILT DISPLAY, DISP1 from OFF to ON and disable the V-LED/LD (TP-L5GV/AV)
automatic cut-off.
8.2 How To Change Operating Parameters
Procedure Key operation Display
1 Press Power ON key while pressing
and holding the Lock key.
The R-TILT DISPLAY is the first
parameter setting.
2 Press SET key to select R-TILT
DISPLAY.
3 The DISP1 parameter highlights to
show it is active. Press [ ] key to
select [ON] for DISP1.
＋
Power ON
PARAMETERS
V-LD - - - [ 30 ]
[R-TILT DISPLAY ]
*1
PARAMETERS
DISP2 [ ON] OFF
DISP1 ON [ OFF ]
PARAMETERS
DISP2 [ ON] OFF
DISP1 [ ON] OFF