5
STEP 3: Power on the gate opener to test. Power off the exit wand and turn the sensitivity board
clockwise to increase the sensitivity, turn it counter-clockwise to decrease the sensitivity. If the
sensitivity is still too high when the sensitivity board has been adjust to Min., you can disconnect the
sensitivity board and ensure the YELLOW wire of the wand is floating (wired to nothing else) to try it
again.
Troubleshooting
1. Ensure all the wiring connections are correct before testing.
2. Ensure there is no moving object around the wand and then try it again.
TOPENS Website
www.topens.com
Any question, please do not hesitate to contact us:
E-mail: support@topens.com
Kindly include your Product Model, Purchasing Date & Site, Order #, and your contact information. All
your concerns will be replied within 24 hours.
Tel: +86 (571) 8908 0213 (China)
Mon-Fri 9:00AM-5:30PM (UTC +08:00)
To Previous Page
Loading...
