32 Service Search
To use USALS, select the Instal-
lation > USALS Setting menu.
At first you have to set the Mo-
torized DiSEqC 1.3 option to
Enable.
To calculate every satellite position, perform the following steps:
1. Choose your desired satellite at the Satellite Name op-
tion.
2. Select the tuner that is connected to the motorized an-
tenna at the Tuner Select option.
3. Input your location to the My Longitude and My Latitude
options with the
V− ,
V+ and numeric buttons.
4. Input the position of your selected satellite to the Satel-
lite Angle if it is not correct.
5. Select the Goto the position option. Then the antenna
will turn toward your selected satellite calculating its
position.
6. If the receiving quality, which is displayed on the right
bottom on the screen, is not good, then tune the antenna
finely with the options of the Move menu. The changed
position is automatically saved at one. At this time you
had better check the receiving quality of every trans-
ponder and choose the best one at the Transponder (or
Frequency) option. It will be helpful to your fine tuning.
To Next Page
Loading...
Need help?
General