9.2 Configuring the digital receiver 81
Whenever the digital receiver is restarted, the dynamic IP ad-
dress will be changed and you will have to check it at the
WLAN Status menu to access the digital receiver. To avoid
this cumbersome thing, you had better assign a static IP ad-
dress rather than dynamic one.
Set the DHCP option to Off, then the IP Address, Subnet Mask
and Gateway options become enabled. You have to set these
options to match the configuration of your router.
Set the User ID and Password options as you desire. You will
be asked for the account made with these options when you
access the FTP server.
NOTE
You can access the FTP server with an anonymous account.
However, with an anonymous account you can only down-
load files. You cannot upload files.
Advance configuration
To configure the network envi-
ronment for the digital receiver
in detail, select the Installation >
LAN Setting > Advance Config-
uration menu.
The available values of each op-
tion are as follows:
Wireless Mode
0: 802.11 B/G mixed.
1: 802.11 B only
TX Burst
802.11 B/G Protection
0: Auto
To Next Page
Loading...
Need help?
General