Topkodas PROGATE - Page 43

PROGATE User manual V-2022-09-20 43 | EN
INST000000˽071˽N#VALUE #
Programming of minimal sensors value upon reaching the SMS message with „Low Alarm“
text will be sent
071= command code (min sensors value upon reaching which, the SMS message with „Low Alarm“
text will be sent)
N = sensor number
VALUE = Format 0000.00 Low Alarm Value
INST000000˽072˽N#VALUE#
Programming of sensor max value upon reaching the selected output will be activated. For
example cooling equipment
072= command code (sensor max value upon reaching the selected output will be activated.)
N = sensor number
VALUE= Format 0000.00 sensor max value upon reaching, the selected output will be activated.
INST000000˽073˽N#VALUE#
Programming of sensor min value upon reaching the selected output will be activated. For
example heating equipment
073= command code (sensor min value upon reaching the selected output will be activated.)
N = sensor number
VALUE= Format 0000.00 Sensor min value upon reaching which, the output will be activated.
INST000000˽090˽NewInstPsw
Change installer‘s password (Installers password should be changed before exploitation of the
module)
090= command code (Change of installer‘s password)
NewInstPsw = New Installer‘s password.
INST000000˽091˽NewUserPsw
e.g.
INST000000˽091˽654321
Change user‘s password (User‘s password should be changed before exploitation of the module)
091= command code (Change user‘s password)
NewUserPsw = New user‘s password.
INST000000˽092
Remote reset of the module via SMS messages
092= command code (Remote reset of the module via SMS messages )
INST000000˽093˽yyyy/MM/dd#HH:mm#
Time of the module setting via SMS message.
The time is usually synchronized via a server or mobile network. However, if synchronization is disabled, it can be set manually via
SMS.
093= command code (Time of the module setting via SMS message)
Time format of the module:
yyyy/MM/dd#HH:mm#
yyyy -year
MM-month 1-12
dd - day of the month 1-31
HH-hours 0-23
mm- minutes 0-59
INST000000˽094˽TEL#SMS
e.g.
INST000000˽094˽+370616111111#Hello
SMS from the module forwarding to the other phone number
094= command code (SMS from the module resending to the other phone number)
TEL = phone number to which will be forwarded sms text
SMS = sms text that will be send to the referred number.
TEL=861611111111 local number or international format e.g. +370616111111
SMS text =Latin Charset
After this commands could not be other commands like: 094 SMS 030 1
because all messages will be forwarded to other numer "SMS 030 1"
INST 000000˽095˽E
Zone Walk Test request
095= command code (Zone Test request)
E = 1- test request activated, 0- test request deactivated
When zone is activated, the bell generates the sound,
ARM/DISARM system automatically turn off this function
INST 000000˽096
Fire sensors reset.
INST000000˽100˽N
System state request:
100= command code (System state request)
N = System state request type
1- System test request, Request information about the module (: IMEI, FW, LEVEL etc.)
2- the values of active sensors request
3 -Request about active zone states
4 -Request about output states
5 - System state request. The module will send information on input/output states and system state
(ARM/DISARM/STAY).