Figure 77: Minimum carrier board space requirement (dimensions in mm)
If components need to be placed under the module, the maximum required component space of
the Apalis module needs to be considered. The following figure shows the maximum occupied
volume at the bottom side of the Apalis module.
Figure 78: Maximum space requirement of components on module (bottom view)
On the bottom side of the module, components with a maximum height of 1.8mm are permitted.
Components soldered on the top side of the module can be up to a maximum of 3mm in height.
Figure 79: Maximum height of components on module (dimensions in mm)
To Next Page
Loading...
