TROUBLESHOOTING
TROUBLESHOOTING
If you're having troubles with your BT30 spindle, read the following troubleshooting procedures:
Machining Operations are Loud ("Chattery") 41
Can't Load or Unload a Tool, or the Spindle's Drawbar Drags Against the Power Drawbar Cylinder's Piston
Bolt 44
Machining Operations are Loud ("Chattery")
Cause: Inappropriate cutting parameters or CAMsettings.
Probability How-To Steps
High 1. Verify that you're using the correct cutting parameters: use the feed rate and
spindle overrides to adjust cutting parameters during operation.
2. Confirm that tool offsets are correct.
Cause:Worn or broken cutting tools.
Probability How-To Steps
High Inspect for worn or broken cutting tools, and replace as necessary.
Cause: Swarf in the spindle or on the tool holder's shank.
Probability How-To Steps
Medium 1. Inspect inside the spindle and on the tool holder's shank for swarf. If necessary,
clean the components.
2. Verify that the spindle and tool holder's contact surfaces are clean, dry, and
free of grease or oil.
Page 41
©Tormach® 2021
Specifications subject to change without notice.
tormach.com
TD10705: Installation Guide: BT30 Spindle Upgrade Kit for 1100M+ (0521A)
To Next Page
Loading...
General